Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

2.5T_/<ouki · 03-21-2016, 01:26 AM

When installing the JGS rubber transmission mount to the cross member, you are required to drill a 7/16 diameter hole in the center of the two factory mounting holes. That's fine and done with, however I would have figured the design would have implemented the factory mounting holes as well as the JGS poly mount is this way.

The rubber mount I have & 7/16 hole drilled in the center. Factory mounts not used?

Picture of the poly mount. Factory mounts used as well as 7/16 stud.

03-21-2016, 01:26 AM	#1
2.5T_/<ouki Zilvia FREAK! Join Date: Oct 2011 Location: SoCal Posts: 1,150 Trader Rating: (13)	JGS Rubber tranny mount help When installing the JGS rubber transmission mount to the cross member, you are required to drill a 7/16 diameter hole in the center of the two factory mounting holes. That's fine and done with, however I would have figured the design would have implemented the factory mounting holes as well as the JGS poly mount is this way. The rubber mount I have & 7/16 hole drilled in the center. Factory mounts not used? Picture of the poly mount. Factory mounts used as well as 7/16 stud.