Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

Turb · 09-04-2016, 05:34 PM

Ok so I just finished my 1uz swap except for 1 thing I can't seem to get the car into gear when the motor is running. I replaced the master cylinder and slave thinking it was that I don't have a clutch dampener and replaced the hardline with a steel braided.

Problem: Basically after I bleed the clutch the, clutch pedal is firm to push down but won't come up by itself, as well I can't get the car into gear while its running, I have a extended throwout specific for this application.
Any help is appreciated, thanks.

09-04-2016, 05:34 PM	#1
Turb Leaky Injector Join Date: Jun 2015 Location: Arizona Age: 28 Posts: 88 Trader Rating: (0)	Trans won't go into gear when car is on Ok so I just finished my 1uz swap except for 1 thing I can't seem to get the car into gear when the motor is running. I replaced the master cylinder and slave thinking it was that I don't have a clutch dampener and replaced the hardline with a steel braided. Problem: Basically after I bleed the clutch the, clutch pedal is firm to push down but won't come up by itself, as well I can't get the car into gear while its running, I have a extended throwout specific for this application. Any help is appreciated, thanks.