View Single Post
Old 12-10-2004, 03:03 AM   #11
mav1178
Zilvia.net Advertiser
 
Join Date: Apr 2002
Location: Hacienda Heights, CA 91745
Posts: 1,524
Trader Rating: (19)
mav1178 is close to perfectionmav1178 is close to perfectionmav1178 is close to perfectionmav1178 is close to perfectionmav1178 is close to perfectionmav1178 is close to perfectionmav1178 is close to perfectionmav1178 is close to perfectionmav1178 is close to perfectionmav1178 is close to perfectionmav1178 is close to perfection
Actually I want to be explicitly clear.....

I AM RIGHT.

I know because I HAD Attain hubs on my S13, then I changed my entire front setup to S14 spindles/hubs with S13 LCA and S14 ball joint pressed in, with sleeves machined for the S13 strut.

I speak from experience.

Or read here: http://forums.freshalloy.com/ubbthre...b=5&o=&fpart=1

Or quoting what I wrote:

-S13 uses 30mm front hub bolt, S14 uses 32mm front hub bolt. Both chassis uses 36mm rear hub bolt.
-Conversion to 5 lug on S13 chassis requires S14SE/Z32nonturbo rear hubs, and either 1) JDM aftermarket front S13 5 lug hubs, or 2) S14 SE front hubs + S14 spindle + S14 ball joint w/LCA (and redrilling of strut for larger strut bolt).
-Conversion to 5 lug on S14 requires S14 SE front hubs and S14SE/Z32nonturbo rear hubs.

And some info on using S14 front spindles on a S13:
http://forums.freshalloy.com/ubbthre...fpart=all&vc=1

-alex
mav1178 is offline