Quote:
Originally Posted by CompleteXen
Definitely sounds like a rack issue. Just in case check the rack bushings and make sure the ball joints are good and tightened down all the way.
|
Ball joints are good, rack bushings are PBM solid so no movement there.
Quote:
Originally Posted by CompleteXen
Worn out teeth in the rack can cause the rack to skip.
|
It's not skipping. Like I said, it turns smoothly. By dead zone I just mean there's a section of turning where it just sticks. If I make a 90 degree turn it starts to re-center but then just stops.
Quote:
Originally Posted by silviaks2nr
Sounds like a bad worm gear in the rack.
|
So You wouldn't waste your time on a rebuild?