View Single Post
Old 11-16-2016, 06:58 PM   #9
Hoffman5982
Post Whore!
 
Hoffman5982's Avatar
 
Join Date: Jan 2009
Location: Definitely NOT FL....
Age: 32
Posts: 2,504
Trader Rating: (25)
Hoffman5982 is just really niceHoffman5982 is just really niceHoffman5982 is just really niceHoffman5982 is just really niceHoffman5982 is just really niceHoffman5982 is just really niceHoffman5982 is just really niceHoffman5982 is just really niceHoffman5982 is just really niceHoffman5982 is just really nice
Quote:
Originally Posted by CompleteXen View Post
Definitely sounds like a rack issue. Just in case check the rack bushings and make sure the ball joints are good and tightened down all the way.
Ball joints are good, rack bushings are PBM solid so no movement there.

Quote:
Originally Posted by CompleteXen View Post
Worn out teeth in the rack can cause the rack to skip.
It's not skipping. Like I said, it turns smoothly. By dead zone I just mean there's a section of turning where it just sticks. If I make a 90 degree turn it starts to re-center but then just stops.

Quote:
Originally Posted by silviaks2nr View Post
Sounds like a bad worm gear in the rack.
So You wouldn't waste your time on a rebuild?
__________________
Hoffman5982 is offline   Reply With Quote