[Billcriss]

I have an event this Saturday so this is very urgent. I installed the autometer water temp gauge with the powered by max adapter that goes on the radiator hose. The issue Is I'm not getting any readings. The gauge when switch on does the slight move showing that it works but when I run the motor the tach doesn't rise. I tried to bleed the system by jacking the front up about a foot and leaving the cap off the radiator but after ten minutes it boils over and vaporizes. I installed a new thermostat (mishimoto 160degree) and still nothing. Any ideas what I could be doing wrong?


Sent from my iPhone using Tapatalk