01-26-2019, 09:50 PM
|
#680
|
Zilvia FREAK!
Join Date: Jan 2003
Location: Socal
Posts: 1,454
|
Quote:
Originally Posted by RalliartRsX
Question for anyone running the Mazworx kit. Need some help with this issue (will send Mazworx an email on Monday)
My setup
Comp Clutch White Bunny
Sr20VET
Mazworx Bell housing
Comp Clutch TOB and SR sleeve
Two setups:
1) Z33 fork, Z33 pivot ball, SR TOB sleeve, Comp Clutch TOB. The issue is, when I go to install, the TOB and clutch fork comes into contact with the PP before the tranny is fully seated. Essentially, the clutch fork is fully against the front part of the opening, which means the Fork/TOB sits too far forward on the center housing
2) If I use the Z33 pivot ball (shorter pivot ball), but SR fork, SR TOB sleeve and Comp Clutch TOB, the tranny will completely sit flush with engine and the clutch fork sits perfectly center in the opening (which makes no sense). However 2 issues
a) I have no idea what the distance between the TOB to the PP should be (no mention of it in the FSM)
b) Clutch Fork specs (what distance should it be in the opening, distance for the clutch arm to move, etc). No specs on Clutch fork in FSM either
It almost seems like the bell housing boss used to mount the pivot ball, is too tall.
|
I thought you were supposed to use the Sr clutch stuff with the mazworxs kit.
__________________
95 240sx RB20 415whp
91 Nx2000 VVL yo
|
|
|