Thread
:
K24-T hold the A
View Single Post
04-02-2019, 06:28 PM
#
30
foreverdeath
Zilvia Junkie
Join Date: Sep 2012
Location: va beach
Age: 31
Posts: 321
Trader Rating: (
3
)
New class schedule gives me a good bit of time to work on the project in the afternoons. Today I got cracking on finishing the oil pan. added bungs for the turbo drain, temp sensor and a -6 for oil drain. Used some hinges and 16ga to make the baffles for the pan. At this point only 2 more things are holding me up from putting the motor in for the last time. Hammering the transmission tunnel on the drivers side of the tranny bracket on the body to clear the CD009 and final welding of the motor mounts on the subframe.
foreverdeath
View Public Profile
Find More Posts by foreverdeath