Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

Bleakley · 07-07-2019, 08:12 PM

How has everyone been drilling out their 300zx rotors to fit their 4 lug car?
I’m doing ANOTHER 300zx brake swap on a car I bought. However, this time I’m burying it all under the stock rims using the 26mm brakes.
Autozone rotors come 5-lug, I need em 4-lug. My idea was to buy a hub from Autozone and use that as my guide (take the lugs out, put the hub over the 300zx rotor and use the lug holes as my guides). My fear though is if that’ll be a tight enough centering tool.
Other idea was to turn down pipe at work to make a real tight fit and center an old 4-lug rotor over the new 5-lug rotors.

If I end up making a tool. Figured I’d see if any of you guys want some to make your lives easier? Not even sure what I would charge to be honest.
But yeah, if anyone has better ideas, I need to hear em.

07-07-2019, 08:12 PM	#1
Bleakley Zilvia Addict Join Date: Apr 2011 Location: Near Pittsburgh, PA Posts: 637 Trader Rating: (1)	Drilling 300zx rotors for 4 lug (tool?) How has everyone been drilling out their 300zx rotors to fit their 4 lug car? I’m doing ANOTHER 300zx brake swap on a car I bought. However, this time I’m burying it all under the stock rims using the 26mm brakes. Autozone rotors come 5-lug, I need em 4-lug. My idea was to buy a hub from Autozone and use that as my guide (take the lugs out, put the hub over the 300zx rotor and use the lug holes as my guides). My fear though is if that’ll be a tight enough centering tool. Other idea was to turn down pipe at work to make a real tight fit and center an old 4-lug rotor over the new 5-lug rotors. If I end up making a tool. Figured I’d see if any of you guys want some to make your lives easier? Not even sure what I would charge to be honest. But yeah, if anyone has better ideas, I need to hear em.