Thread: The Sr20/Sr22vet thread
View Single Post
Old 08-06-2019, 08:09 AM   #1101
RalliartRsX
Post Whore!
 
Join Date: Apr 2006
Location: Maryland
Posts: 4,791
Trader Rating: (32)
RalliartRsX is close to perfectionRalliartRsX is close to perfectionRalliartRsX is close to perfectionRalliartRsX is close to perfectionRalliartRsX is close to perfectionRalliartRsX is close to perfectionRalliartRsX is close to perfectionRalliartRsX is close to perfectionRalliartRsX is close to perfectionRalliartRsX is close to perfectionRalliartRsX is close to perfection
Quote:
Originally Posted by S13VE View Post
I was planning on using Taarks push in plug, what did you use?

https://www.efisolutions.com.au/oil-...onversion-sr20
I actually picked up a similar plug recently. However, the current item is threaded and fitted with a M16 I think, plug

Quote:
Originally Posted by brndck View Post
are the threads damaged? does the plug just need some Teflon tape to seal?
So not sure. I doubt the machine shop used Teflon tape. If they did, then I am up a creek as that will require a full block teardown and taking to machine shop to get sorted
RalliartRsX is offline   Reply With Quote