ALL Temp Sensor Setup.
AN TEMP connections on LINK ECU Harness 1 (ANTEMP3,ANTEMP4) already have pull-up sensor built in.
If you need to add another temp sensor to the AUX Cable, you need to wire a 1k ohm pull up resistor like below for it to work.
(Pressure sensor no need for pull-up resistor
Summit wiring DT Wiring kit.... Best deal I can find...
DTM vs DT vs DTP info
Deutsch DTM Series:
This size 20 connector will accommodate wire sizes from 22-16 gauge depending on which contact is used. DTM connectors come in 2, 3, 4, 6, 8, 12 pin configurations. The maximum current (amp) draw on each pin would be 7.5 amps continuously.
Deutsch DT Series:
This size 16 connector will accommodate wire sizes from 20-14 gauge depending on which contact is used.. DT connectors come in 2, 3, 4, 6, 8, 12 pin configurations. The maximum current (amp) draw on each pin would be 13 amps continuously.
Deutsch DTP Series:
This size 12 connectors will accommodate wire from 14-10 gauge depending on which contact is used. DTP connectors are only available in 2 and 4 pin configurations. The maximum current (amp) draw on each pin would be 25 amps continuously.
Now that we have some basic knowledge on the Deutsch DT family of connectors, Lets take a quick look at the contacts or as most people call the “terminals”.
