|
Also for what it's worth, I could not run any of the spacers on my gktech outer tie rods when i installed the GkTech v4 knuckles. The knuckles already drop the tie rod pickup point lower. The tie rod would hit my wheel (17x9). I had to remove all of the spacers from the tie rod shank until it was all the way up, and then cut off the excess length of the shank below the bottom nut.
When i replace them i'll just do a normal outer tie rod at this point since the bump steer spacing isn't needed or useable with the knuckle.
__________________
Quote:
Originally Posted by crimsonrockett
Such a good signature.
|
|