Quote:
Originally Posted by slider2828
Actually on that note guys!!!! I need a little help.
I have a 3qt accumsump..... I am going to run Rotella T5 as a startup oil to get to about 500 miles......
So obviously I am going to fill that accusump.....
So when I switch to AMS Signature.... how do I get all that oil out??
I guess put 60psi in the accusump, to push the oil and drain it....
Any good ideas on how to drain the oil cooler and lines? or screw it a little mix is alright?
-Ken
|
The right way is, drain engine oil, then open the valve on the accusump, let it bleed out.
As for the cooler and lines, ive always disconnected the lines. Put one in a bucket and ran shop air thru it(low psi) can get messy but only way to get all the oil out.
Do not forget to prime the motor backup before starting...