Quote:
Originally Posted by zombiewolf513
Fix the leaks first and check the resistance across the top 2 terminals off the TB. should sweep smoothly between .1 or .2 ohm 'closed' to about 5 ohm when all the way 'open'. Adjust to .45V installed with TB fully closed, should sweep smoothly to 5V at wide open throttle.
|
I checked the resistance of the tps on 20k Ohm setting (only one I could get it to register on) the plug has 6 pins and with the clip facing away from you bottom far left with top middle pin it red 1.67 (closed) and 11.13 (fully opened).
It sweeps smoothly though does this seem high?
I fixed a broken earth going to the o2 sensor but that made no change, I wonder if the o2 sensor is faulty? I can see the ground wire to the engine block is corroded so I?ll order that and change it when it comes.