[slider2828]

If this helps anyone in the future twin discs most of the time will need a shorter carrier. ORCand OSG twins use a 16 to 18mm carrier and our stock sr is 24mm. If you didnt put one in and in my case i didnt, i just cut about 6mm off the slave cylinder pin, dont forget to account for the cutoff wheel thickness a bit... Now i can better see a small air gap. Just make sure to put slop in the pedal and open the clutch reservoir and push everything back a few times to make sure the pin is in resting position. The readjust everything back.

Now the clutch engages at 1/4 of the way up and not like 5/8 of the way up....