Thread: Rod/Main Bearings?
View Single Post
Old 07-30-2005, 10:02 PM   #4
SR240DET
Zilvia FREAK!
 
Join Date: Mar 2002
Location: orida
Posts: 1,490
Trader Rating: (0)
SR240DET has much to be proud ofSR240DET has much to be proud ofSR240DET has much to be proud ofSR240DET has much to be proud ofSR240DET has much to be proud ofSR240DET has much to be proud ofSR240DET has much to be proud ofSR240DET has much to be proud ofSR240DET has much to be proud ofSR240DET has much to be proud ofSR240DET has much to be proud of
Send a message via AIM to SR240DET
Quote:
Originally Posted by BlazedGlory
I have an S13 SR20DET, and plan on doing a slight build before I slap a bigger turbo on, cams, valve springs/retainers, possibly pistons/rods (not sure yet), main/head studs, etc.

I've read it is a good idea to do bearings as well. In searching I read there are different sizes and whatnot? Should they be measured to check engine wear or something before you buy new ones? I found these on ebay - they are available in standard, .25, .50, and .75mm oversized - would I just get standard? I'm just trying to get all the parts together that I can before I even begin to start actually upgrading the engine...

http://cgi.ebay.com/JDM-NISSAN-SR20D...QQcmdZViewItem
http://cgi.ebay.com/JDM-NISSAN-SR20D...QQcmdZViewItem

thanks!

wow... just... wow... not sure if you should touch the internals..... sounds like you gotta some some more research....

are you sure you know what your getting into?
SR240DET is offline   Reply With Quote