|
HyperTek - Dash and Door Panels are being discussed however the cost is not going to be super low but will be very reasonable... just like a door the dash has alot of mounting a structural points. Molding a dash and door panels takes alot of skill.
Cup Holder... I have an S14 and just used the hole in front of the Lid... Adding a Cup holder to the Console Lid would be risky... think about it... thats where your elbow sits. Funny how the S15 has 2 Cup holders and the S13 and S14 get none!
eyustfu - It would be far cheeper to weld a patch... seriously a Carbon Sunroof cover would be Bank... consider the trim work. The mold alone would be 4 parts at least.
ThatGuy - Like I said, door panels are being considered. The Handle trim and the button trim would be seconday parts to the door panel. May offer as Optional parts. The door AC vent would be left for stock (due to vents) so a Carbon Dash Kit can be used.
steering column shroud gauge... seems like good use of a void area... i'll look into it.
Consider the Cost and if you would actually pay for it... ex: $700 for a Carbon Dash? ?
Peace
Drew
|