Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

speedgod^s13 · 12-29-2005, 06:22 AM

Ok, so my friend hooked up my rsm-gp, but since I don't have the instructions, and since apexi, only provides the setting instructions, for the older rsm, I thought i'd try here. Does anyone here, know how the set the rsm, so that my governor, does not kick in? I have tried several ways, but to no avail. Everytime, I almost peg my needle, which is 180kmh, on my cluster, the car refuses to go anymore. I let go of the gas, and when the speed drops, then she responds again. So, i'm assuming, my speed cut is still active. This is on an sr, unless my friend hooked it up wrong, if you guys have a wiring diagram, for the where the wires from the rsm, go to the redtop ecu, that would be good too.

12-29-2005, 06:22 AM	#1
speedgod^s13 Post Whore! Join Date: Nov 2004 Location: Honolulu, Hawaii Age: 45 Posts: 3,194 Trader Rating: (27)	Apexi RSM Ok, so my friend hooked up my rsm-gp, but since I don't have the instructions, and since apexi, only provides the setting instructions, for the older rsm, I thought i'd try here. Does anyone here, know how the set the rsm, so that my governor, does not kick in? I have tried several ways, but to no avail. Everytime, I almost peg my needle, which is 180kmh, on my cluster, the car refuses to go anymore. I let go of the gas, and when the speed drops, then she responds again. So, i'm assuming, my speed cut is still active. This is on an sr, unless my friend hooked it up wrong, if you guys have a wiring diagram, for the where the wires from the rsm, go to the redtop ecu, that would be good too.