Quote:
|
Originally Posted by KA24DESOneThree
The control arms listed on SPL's website are KTS.
I was considering Aurora AMTs. The AMTs are rated at 28k pounds, the FK JMTs at 11.5k with a price difference of about $20 per end. My dilemma with this is listed below.
|
As mentioned several times already, having a rediculous load rating won't prevent failure.
The important part is to make sure the ball and housing material are made of stainless, or something equally resistant to corrosion.
Quote:
|
Originally Posted by KA24DESOneThree
I've been trying to measure it right and I always get 11/16" or 17.5mm. The closest end I've found that actually might fit is made by Fluoro and costs $106 each. WTF, am I just stupid or something? It's 1/8" off 5/8" and 1/8" smaller than 3/4".
|
What are you measuring?
Are you measureing the diameter of the threaded male rod end, or the female insert?
Also, I hope you are using a vernier caliper.
Worse comes to worse, you can always go to a hardware store and see which nut fits the rod end.