Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

VitaminT · 03-25-2006, 01:21 AM

Anyway I guess that was about all to say. Looks like you will have to have the digi combination meter that resides inside the digi cluster. All the rest should be pretty easy based on the colors/diagram for the 12 pin plug on the hud control unit located on EL-42. The entire digi cluster and hud projector completely run off of the two plugs your analog cluster harness is plugged into back up in the dash so you should be able to get all of your wires from there.

Items you will have to have:
analog cluster
analog cluster harness
digital combination meter
HUD projector
time and some wire

I can't imagine the project taking more than a few hours if you have everything. It looks like you only have to run 5 wires all of which are right at the back of your analog cluster. One thing to note is that on EL-43 it looks like it shows just the 5 wires you need for the HUD vs. the 11 you need for the HUD and LCD cluster read out.

Hope all this helps.

Oh also for those that just want the info looks like the wires are Green (power from left 2nd from bottom 10a fuse), Yellow/Green (pin 36 on DE ecu), Yellow Black (Vehicle speed sensor), Yellow Blue (Vehicle speed sensor).

03-25-2006, 01:21 AM	#11
VitaminT GhettoBoost Join Date: Aug 2003 Location: AL Posts: 248 Trader Rating: (0)	Anyway I guess that was about all to say. Looks like you will have to have the digi combination meter that resides inside the digi cluster. All the rest should be pretty easy based on the colors/diagram for the 12 pin plug on the hud control unit located on EL-42. The entire digi cluster and hud projector completely run off of the two plugs your analog cluster harness is plugged into back up in the dash so you should be able to get all of your wires from there. Items you will have to have: analog cluster analog cluster harness digital combination meter HUD projector time and some wire I can't imagine the project taking more than a few hours if you have everything. It looks like you only have to run 5 wires all of which are right at the back of your analog cluster. One thing to note is that on EL-43 it looks like it shows just the 5 wires you need for the HUD vs. the 11 you need for the HUD and LCD cluster read out. Hope all this helps. Oh also for those that just want the info looks like the wires are Green (power from left 2nd from bottom 10a fuse), Yellow/Green (pin 36 on DE ecu), Yellow Black (Vehicle speed sensor), Yellow Blue (Vehicle speed sensor).