I have some 5 lug hubs (2 of which I bought new off ebay. other two are rear z32s) which I will be using for a conversion and just got my 20mm H&R spacers.
The spacers do not fit flush against the hub because of a small lip towards the bottom of the center of the hub and there is no cutout in the center bore of the spacers for that small lip.
The spacers have a 66.2mm center bore which is what the TOP of the hub is and it slips on great until it hits that small lip on the bottom of the shaft/hub making a small gap between the spacer and the flat part of the hub.
So how the hell are you guys getting your spacers to fit against the hub??? Id imagine all H&Rs come like that since I got 2 sets... and im pretty sure all S14 hubs have that lil lip on the hub.
Anybody know of any 20mm hub/wheelcentric spacers that will fit on S14 hubs w/ the lip?
Im about to send these H&Rs back
Oh and the part #s on both sets of spacers are 4065662 which is for S14s