Quote:
Originally Posted by slider2828
I think Dakota Digital Released a one box easy wire for CD009 GPS Speed.
https://www.dakotadigital.com/index....rod/prd837.htm
SPEED 2 is a sine wave signal for most older speedometers.
Dakota Digital speedometers, and dash systems, can use either output.
Based on the manual, I can set it to a 16K PPM signal.....
https://www.dakotadigital.com/pdf/GPS-50-2.pdf
Then I wire it to the cluster. Once I have the signal wire from the Dakota, do I just wire back into the speed sensor harness?
I guess to where the sensor use to be which is on my KA24E harness, tranny harness Y/G wire? |
Hey All,
Installed and it worked!!! The install was soooo easy. But you do need to remove the dash. Pulled constant 12v and acc 12v from the ignition tumbler. Then ground from anywhere. Then cut and wire in a wire from the dash (wire 6 y/lavendar) to speed 2 which is a sine wave and 16ppm setting.... now you have a gps and accelerometer speedo.
[img size=150]https://i.imgur.com/2iT0uXO.jpg[/img]