Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - This is the roll center, suspension pickup, and steering angle modification thread.

tuzzio · 03-28-2022, 05:05 AM

I should probably just PM Poorman, but..

I replaced my RUCA this past weekend due to bad heims. (Contemplating replacing the toe and traction rods while i'm at it) but before I go to get an alignment, is there anything I should adjust for any sort of advantage? I know thats a very vague question. The car is a strict street car. So basic alignments have always been fine. Figured its worth asking as i've seen people say "Adjust X rod for X result".

Edit: Just saw his comment about traction rod being extended the same length as my camber arm. I should stop going on the forums at 6AM... I have his number. I'll text him.

03-28-2022, 05:05 AM	#7891
tuzzio Post Whore! Join Date: Oct 2013 Location: Western Mass. Posts: 2,605 Trader Rating: (3)	I should probably just PM Poorman, but.. I replaced my RUCA this past weekend due to bad heims. (Contemplating replacing the toe and traction rods while i'm at it) but before I go to get an alignment, is there anything I should adjust for any sort of advantage? I know thats a very vague question. The car is a strict street car. So basic alignments have always been fine. Figured its worth asking as i've seen people say "Adjust X rod for X result". Edit: Just saw his comment about traction rod being extended the same length as my camber arm. I should stop going on the forums at 6AM... I have his number. I'll text him. Last edited by tuzzio; 03-28-2022 at 06:42 AM..