Had a couple hrs today to put towards the Z..
This is the cage that was done by the fabricator. I am scrapping every part of it that was done - about 40' of DOM scrapped unless I can salvage some short pieces out of them.
Main hoop has ~3" between it and the roofline. Note the gnarly plasma cut strut tower holes.
The door bar stuck below the roofline.
The A-Pillar was fairly tight...
Took the S30 front subframe and nipped off the factory motor mounts..
Picked up a R33 GTR RHD steering rack. RHD because when you flip the rack over, I need it to work in that direction with the S14 knuckles flipped right to left (steering rack in front of subframe instead of factory).
Then I took the R34 GTR rear subframe and burnt out the factory bushings, sawz-all to the top flange and air hammer to push the sleeves out.
SPL V1 Solid Subframe Bushing in the bore.
Tomorrow night's plan is to brace the subframe, ditch the diff bushings, find a bushing for the R33 steering rack and send out subframe(s) to JP @ Strip tech for powdercoating.