Quote:
Originally Posted by mr.nismo.
Wanted some opinions: just got my trans installed with my os giken super single (sr20). I have the shorter pivot ball in, but the slave is relaxed at full extension and the TOB barely touches the pressure plate. I'm thinking the longer pivot ball will fix this issue. When compared to my old clutch/flywheel, it's shorter in height. I know everything with this swap is very one off with your personal setup, but wanted to see if anyone else has the issue of it not reaching.   
Sent from my Galaxy Note 10+ using Tapatalk |
Did you get this figured out? I'm looking for the same opinion.
The TOB is touching the pressure plate here. It looks like I have a little bit more room for the fork to swing.
Below is with the slave installed and the fork at the point where the TOB is touching the pressure plate. It seems like the slave can extend further. I'm hoping to clarify if this looks normal/like it will work before it goes in the car.
