|
The issue with out using filler is that if you have any gap (which you will if you are cutting and making this into an exhaust) you will have to use filler so usually its best to learn with it. I unfortunately dont have time to go buy anything thin to practice on, instead I am working with mostly 1 1/4 inch piping .120 wall to practice with for my neighbor since thats mostly all he works with and once he thinks I am good enough, will give me some of his side jobs, etc.
Not that its a bad thing, just practicing with thinner material is a lot better for learning purposes as it is not as errr.. forgiving so could go too hot and blow a hole or two cold and not make a proper weld.
No clue the hell I am talking about, ignore me most likely...
__________________
S14 KA NA two cylinders, 75whp limper
|