Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - Mazworx Weld-In Roll Bar Kit! One of its kind!

BlazedGlory · 04-11-2010, 08:20 AM

I've never installed any sort of cage before, so maybe I am doing something wrong... but, how tall is the S13 pre-welded roll bar section supposed to be? Either I am going about getting it in the wrong way, or this thing is a couple of inches too tall. Am I supposed to have to trim it down to fit? Damn, I thought I was going to get it all tacked up at least today =/.

EDIT: I tried removing both seats completely and putting it in the other way before I measured the height of the bar around 44" and it looks like with some VERY heavy persuasion I only have about 42" to work with...

04-11-2010, 08:20 AM	#158
BlazedGlory Zilvia Junkie Join Date: Jan 2003 Location: Canton, GA Posts: 370 Trader Rating: (1)	I've never installed any sort of cage before, so maybe I am doing something wrong... but, how tall is the S13 pre-welded roll bar section supposed to be? Either I am going about getting it in the wrong way, or this thing is a couple of inches too tall. Am I supposed to have to trim it down to fit? Damn, I thought I was going to get it all tacked up at least today =/. EDIT: I tried removing both seats completely and putting it in the other way before I measured the height of the bar around 44" and it looks like with some VERY heavy persuasion I only have about 42" to work with... Last edited by BlazedGlory; 04-11-2010 at 07:47 PM..