I received 6
flat 6"x6" plates for my 6 pt. bar... They are not bent to fit in 1 shot like mentioned. Just from looking at it I am definitely going to have to bend the plates for the rear strut towers
at the very least.
EDIT:
Plates properly bent to fit in 1 shot. Before I read that first post again I was just planning on tacking these particular plates top and bottom then hammering in the sides to contour to the towers. Not a huge deal, but why advertise them as being pre-bent?:
Someone please tell me if I am doing something wrong here. Did anyone else have to cut theirs down to fit? Perhaps I have some oddball 240SX that has a shorter cabin...
