[TheRealSy90]

Just to post some more info in here, those of you using the Mazworx bellhousing kit MUST either change the pilot bushing in the crankshaft to the revised and shorter Nissan needle bearing, or cut the copper bushing shorter by 1/8". If not the transmission input shaft will bottom out in the crank shaft and potentially damage thrust bearings etc, even after trimming the input shaft stub in accordance with the kit instructions.


Also, apparently the Tomei stroker cranks require the pilot to be trimmed even further than 1/8" as the crank is not machined out as deep as an oem crankshaft. Meaning the needle pilot can't be used as it cant be trimmed.
As far as I know nobody has tried it with a BC stroker crankshaft yet.


Regarding clutches, the Mazworks bellhousing was built around a Comp triple plate clutch just to make sure that it should fit any clutch option you could possible have lol.