[S13project]

After finding out the motor needed to pulled out and torn down again for inspection....not what I had hoped to deal with, but ended up being glad we did. Previous motor builder decided to phone it in and play mismatch with the #4 rod caps. Did same with mains along with some junk nasty bearing. All together causing the motor to refuse to turn over when we went to turn nit by hand (my own fault for waiting until it was in the car, but this was a 'trusted' motor builder). To top it all off the front cover was not decked with the block so would've immediately blown the head gasket upon start up with my luck. Thus why it ended up being a good thing. After tearing it down to see what the was fuss I took the motor to Sammy Tiger at Tiger Racing to give it a full overhaul. Spins like butter now and is back in the car (3rd times the charm right?!?). Slapped on a couple more parts......still a few more to go but it's finally nearing the day it goes to the tuner for base tune, break-in, and then full tunes.