Pulled the baffles out of the stock gas tank in preparation for the hydromat install. All but one of the factory spot welds was already broken, so I just had to wiggle it off and then bend it all up so it fit out the sending unit hole.
New and improved puck mounts on.
Cheap ass tension rods from the other car and swaybar installed.
Fender braces in.
Seat and Nardi in.
Not much chassis work left, and then I have to get the engine in so I can start building lines for the swirl pot, etc. Still waiting on gaskets from Nissan Japan, I guess they've been backordered for a while.