Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - Writeup: custom Koni and Ground Control coilover setup assembly

koukimatt · 10-28-2009, 02:42 PM

A while back, I got a set of Koni Yellows and the Ground Control kit with sleeves and 400/300 Eibach ERS springs. It worked ok on my S14 but it made a lot of noise -- mainly squeaks and creaks in the rear -- and I didn't have camber plates for the front so I couldn't get the car aligned properly. I swapped out that setup for a set of Stances with 8/6 springs, and recently I traded the Stances to my brother for Tanabes with 10/8 springs. The Tanabes are too low for me, even at their highest point, and both the Stances and Tanabes are too harsh.

My question is: can I convert the Koni Yellow + GC setup to something similar to what OptionZero did? What parts do I need to do it?

10-28-2009, 02:42 PM	#81
koukimatt Join Date: May 2007 Location: Dallas Posts: 37 Trader Rating: (0)	Convert Yellow + GC to this setup? A while back, I got a set of Koni Yellows and the Ground Control kit with sleeves and 400/300 Eibach ERS springs. It worked ok on my S14 but it made a lot of noise -- mainly squeaks and creaks in the rear -- and I didn't have camber plates for the front so I couldn't get the car aligned properly. I swapped out that setup for a set of Stances with 8/6 springs, and recently I traded the Stances to my brother for Tanabes with 10/8 springs. The Tanabes are too low for me, even at their highest point, and both the Stances and Tanabes are too harsh. My question is: can I convert the Koni Yellow + GC setup to something similar to what OptionZero did? What parts do I need to do it?