So, I got a question for everyone. I'm about to order my adapter kid from my jz/cd swap.
Measurements:
a340 Bellhousing
14 3/8" exterior diameter (top to bottom), 4 3/4" depth; 13" inside diameter, input shaft is centered @ 6.5"
CD009
16" exterior diameter (top to bottom), 6 3/4" depth (to second rib where cut is made); 13 1/4" inside diameter, input shaft centered @ 6 5/8"
Assuming the no-cut adapter ring is 1/2" and the "cut kit" adapter flange is 1.5", the overall length would be shorter with the cut kit (1.5"), while also having about an inch extra ground clearance, and less firewall bashing.
Is it worth the extra money converting to an internal slave set-up needed for the cut kit since my CD is external with a new slave?
__________________
Key'd Performance
@jz_2tone
|