View Single Post
Old 08-02-2020, 02:08 AM   #942
mr.nismo.
Nissanaholic!
 
mr.nismo.'s Avatar
 
Join Date: Feb 2012
Location: Oxnard, CA
Age: 30
Posts: 1,890
Trader Rating: (31)
mr.nismo. has a reputation beyond reputemr.nismo. has a reputation beyond reputemr.nismo. has a reputation beyond reputemr.nismo. has a reputation beyond reputemr.nismo. has a reputation beyond reputemr.nismo. has a reputation beyond reputemr.nismo. has a reputation beyond reputemr.nismo. has a reputation beyond reputemr.nismo. has a reputation beyond reputemr.nismo. has a reputation beyond reputemr.nismo. has a reputation beyond repute
So I got everything installed driveline wise. I had clearance issues with my drive shaft and shifter. Just throwing my setup on here for anyone looking to do the conversion.

SR20
Drift freaq motor mounts
Gk trans x member and mount
Rear subframe has solid riser bushings
Gk shifter and shaftmasters aluminum one piece abs shaft
Abs diff

Gk clearly lists their clearance at 90mm max. The widest part of the joint is 110mm, so obviously not going to work as is. The engine sits lower and subframe sits higher, giving the driveshaft a more straight line. The widest part is on the shaft side, and may have cleared with normal height engine mounts and subframe bushings (more tilt in the shaft). None the less, I shaved the dog leg down to clear. It's made of chromoly, and honestly don't see it breaking even with it being shaved.

Sent from my Galaxy Note 10+ using Tapatalk
mr.nismo. is offline   Reply With Quote