Hello
A quick question:
I want to fabricate hard oil lines with banjo ends for solenoid relocation bracket and fit the bracket on the engine block(under the intake preferably), because as I've found, hoses with AN fittings leaks no matter how tight I screw them. Leakage is barely noticeable, but it definitely takes place.
I googled and found a couple of photos, with possible bracket locations,
but I just cannot redo the same, I have S14 block and stock heater lines take almost all the place under intake collector:
Could any proficient one advise a way of securing Mazworx solenoids bracket on the block?