Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - second chance two-tone

snorkelcoupe · 11-10-2018, 08:18 AM

I've just been knocking out some small stuff during the course of the summer and early fall. The time has been spent cleaning up more rust in the engine bay, SEM dying the rear seats black, painted the steering rack and finished cleaning the transmission.

What're hog rings?

I painted the trans with VHT silver but I forgot to take a picture

it'll probably break anyways

I picked up a set of Stance GR+ coilovers, I took some time to apply new anti-seize and installed new boots on the rear. The rear subframe was pulled once again to install the GK tech bits (arms, weld in plates and axle spacers.) I painted the knuckles, replaced the front wheel bearings, installed GK tech RC correction bits and I resprayed the front subframe and tension rod bracket to match the rear subframe.

]

11-10-2018, 08:18 AM	#47
snorkelcoupe Zilvia Member Join Date: Oct 2014 Location: VA Age: 31 Posts: 207 Trader Rating: (3)	I've just been knocking out some small stuff during the course of the summer and early fall. The time has been spent cleaning up more rust in the engine bay, SEM dying the rear seats black, painted the steering rack and finished cleaning the transmission. What're hog rings? I painted the trans with VHT silver but I forgot to take a picture it'll probably break anyways I picked up a set of Stance GR+ coilovers, I took some time to apply new anti-seize and installed new boots on the rear. The rear subframe was pulled once again to install the GK tech bits (arms, weld in plates and axle spacers.) I painted the knuckles, replaced the front wheel bearings, installed GK tech RC correction bits and I resprayed the front subframe and tension rod bracket to match the rear subframe. ]