Decided I wanted to keep the heater control valve. Couldnt find any pre-bent hoses that I think would work, so I picked up a 6ft length of 3/4" heater hose and some L pieces to make my own.
Got my oil and tranny fluid
Valve cover fresh from the powder coater
With stuff on it
On the motor
Did some little things. Mostly finished with mounting my battery box in the trunk, didnt grab pictures but I will when I wrap it up.
Bent the bracket on the oil filter relocation kit and found a good spot to mount it on the strut tower. Need some smaller self tapping screws to finish that up. No pics yet.
Got some hose clamps for some lines...the one on the cold pipe is now clamped. Cut my radiator hose down to size and clamped both of them down. Again, no pics right now.
Having troubles figuring out how to place the air intake pipe. It seems to be a very tight spot between the power steering reservoir line to the pump, and then the AC line (specifically the lo-port filling point). How in the world do people fit it in there?