Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

R@tch · 01-11-2010, 07:12 AM

Unfortunately I've never seen any dynographs from the endless-r sr20dett. The s14 it was in has been sold in parts late 2008. These figures are from their website.

There are some other twinturbo sr's out there:

Edit; found a dyno sheet for the endless-r sr20dett on sxoc.com

quote from Endless-r guy:
"Here you go guys, dyno chart....very hard to explain...old bosch dyno that we only use for setting the base map.

We dynoed the car on low boost first time too see the loss power, (we knew the car would go off the chart), so on the second time, we reset the start point (each . is 2.6ps)

The loss power was 65ps
the loss power on the altered start location is 78ps
Above chart reading is 20.8ps
Pressure adjust is multiplied by 1.05

We power ran the car at 1.9bar boost, but the wheel began to spin...power here reads 549.99ps....not taking into effect the wheel spin.

Again, we only run the cars on the dyno for base mapping, not for power checking as we race the cars on the strip, and thats where we get our data logs, (kg check the cars, terminal speed/ET...gives us a better idea how the car is performing....(set up etc, not just engine power)

Car runs 2.2bar on the strip, but we had mission problems (1-2nd gear) but terminal speed was very nice over 220kmh...with slow gear changes...so alot more to come."

specs:
TRUST GReddy TD05-16G ×2
Trust forged piston 86.5mm
Trust 87mm 1,2mm head gusket
Trust Big oil pan
HKS Head System
Cam264°/272°
Trust aluminium slide cam pulley
Endless original Surge tank
90mm throttle for Infinity
Surd 1000cc injector
RH9 big fuel pump
Surd fuel collector tank
Endless original pro liner
Surd fuel regulator
Trust waste gate type R
Original Manifold
Buttery moving
Trust Aluminium radiator
Original oil catch tank
Original radiator collector tank
HKS F-conV PRO
TRUST ProfecB SpecⅡ
HKS 3layers inter cooler

quote from endless-r guy:
"Re power, we have already run 220km in the 1/4, so yes the system does work, the power reading was on 2.1ltr engine only, but head was lash killer and fully tuned, so we have 9000rpm limt, when we made 550hp on the dyno, it was at 1.9bar, we ran 220kmh at 2.1bar....so power judging by the dyno graph would be over 600hp.
TO make the kit work, a stroked engine is needed. 2.0 CA18 and 2.2 SR20 with race heads will be best, this is not a normal street engine....we know that, but its good to be different, and for thoes who have the above setups already, its a very interesting kit."

01-11-2010, 07:12 AM	#5
R@tch Leaky Injector Join Date: Sep 2005 Location: Netherlands Posts: 126 Trader Rating: (0)	Unfortunately I've never seen any dynographs from the endless-r sr20dett. The s14 it was in has been sold in parts late 2008. These figures are from their website. There are some other twinturbo sr's out there: Edit; found a dyno sheet for the endless-r sr20dett on sxoc.com quote from Endless-r guy: "Here you go guys, dyno chart....very hard to explain...old bosch dyno that we only use for setting the base map. We dynoed the car on low boost first time too see the loss power, (we knew the car would go off the chart), so on the second time, we reset the start point (each . is 2.6ps) The loss power was 65ps the loss power on the altered start location is 78ps Above chart reading is 20.8ps Pressure adjust is multiplied by 1.05 We power ran the car at 1.9bar boost, but the wheel began to spin...power here reads 549.99ps....not taking into effect the wheel spin. Again, we only run the cars on the dyno for base mapping, not for power checking as we race the cars on the strip, and thats where we get our data logs, (kg check the cars, terminal speed/ET...gives us a better idea how the car is performing....(set up etc, not just engine power) Car runs 2.2bar on the strip, but we had mission problems (1-2nd gear) but terminal speed was very nice over 220kmh...with slow gear changes...so alot more to come." specs: TRUST GReddy TD05-16G ×2 Trust forged piston 86.5mm Trust 87mm 1,2mm head gusket Trust Big oil pan HKS Head System Cam264°/272° Trust aluminium slide cam pulley Endless original Surge tank 90mm throttle for Infinity Surd 1000cc injector RH9 big fuel pump Surd fuel collector tank Endless original pro liner Surd fuel regulator Trust waste gate type R Original Manifold Buttery moving Trust Aluminium radiator Original oil catch tank Original radiator collector tank HKS F-conV PRO TRUST ProfecB SpecⅡ HKS 3layers inter cooler quote from endless-r guy: "Re power, we have already run 220km in the 1/4, so yes the system does work, the power reading was on 2.1ltr engine only, but head was lash killer and fully tuned, so we have 9000rpm limt, when we made 550hp on the dyno, it was at 1.9bar, we ran 220kmh at 2.1bar....so power judging by the dyno graph would be over 600hp. TO make the kit work, a stroked engine is needed. 2.0 CA18 and 2.2 SR20 with race heads will be best, this is not a normal street engine....we know that, but its good to be different, and for thoes who have the above setups already, its a very interesting kit." Last edited by R@tch; 01-11-2010 at 07:37 AM..