Quote:
Originally Posted by jumpman2334
except for the fact that the OP said the pan leaks at some of the welds.
|
I'm not sure if its welds or it from the flange which got little warped, cause I leak tested it before I left for boot camp. Its realy hard to tell on a gloss black pan. I never want it to be the finally pan anyways it got really janky after cutting the back for rack clearance then winging out the sump. When I'm done modeling it up I'll share some screen shots. But I do need some help getting measurements for the oil pan flange. It's close based of what I know from my pan and what moroso says on their site but i I deffinalty need bolt hole locations.
Sent from my SM-G960U using Tapatalk