Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post - This is the roll center, suspension pickup, and steering angle modification thread.

white92_s13 · 01-04-2010, 01:53 AM

ok so this thread inspired me! I had a spare set of knuckles and lower control arms. I took some 1/8th" plate i had and cut it out cleaned it up and boxed the lower control arm. need to weld one more plate on to add some more strength. Then i did some research on Knuckle modification

P/s knuckle TOP and NON p/s knuckle Bottom

These are the "D1 SUPER ANGLE" modified shortened stock p/s knuckles! SHORT!!!!

Anyways I have a friend with a good welder and a oxy acetylene torch and we can heat them up and weld it up nice! Im going to post more pictures of them modified tomorrow!

01-04-2010, 01:53 AM	#184
white92_s13 Leaky Injector Join Date: Mar 2008 Location: goodyear az Age: 35 Posts: 94 Trader Rating: (0)	ok so this thread inspired me! I had a spare set of knuckles and lower control arms. I took some 1/8th" plate i had and cut it out cleaned it up and boxed the lower control arm. need to weld one more plate on to add some more strength. Then i did some research on Knuckle modification P/s knuckle TOP and NON p/s knuckle Bottom These are the "D1 SUPER ANGLE" modified shortened stock p/s knuckles! SHORT!!!! Anyways I have a friend with a good welder and a oxy acetylene torch and we can heat them up and weld it up nice! Im going to post more pictures of them modified tomorrow!