Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

ronnieronron · 12-17-2022, 11:12 PM

Hello, everyone i was wondering if anyone can give me some insight.

i picked up a 96 q45 diff, got the driver q45 axle and a 300zx TT driver side axle put a R32 GTR 2way in in the diff.

I also used one half shaft from the q45 (cause one side didnt fit with the r32 2 way installed and i purchased a s15 30 spline and had my welder weld a 6 bolt on it.

so the diff was complete the only issue i had was when i installed the diff. The driver side Axle (300ZX TT) is compressed. Passenger side seemed fine.
im just concerned with the Driver side axle being compressed so much. i havent drove the car yet. But was wondering if anyone else have done this. (i dont want to bring up 15+ year old threads asking cause they probably wont remember.
im sorry but i dont have pictures.

12-17-2022, 11:12 PM	#1
ronnieronron Join Date: Nov 2019 Location: ca Posts: 26 Trader Rating: (0)	S14 with 1996 q45 Diff/ R32 GTR 2 way Hello, everyone i was wondering if anyone can give me some insight. i picked up a 96 q45 diff, got the driver q45 axle and a 300zx TT driver side axle put a R32 GTR 2way in in the diff. I also used one half shaft from the q45 (cause one side didnt fit with the r32 2 way installed and i purchased a s15 30 spline and had my welder weld a 6 bolt on it. so the diff was complete the only issue i had was when i installed the diff. The driver side Axle (300ZX TT) is compressed. Passenger side seemed fine. im just concerned with the Driver side axle being compressed so much. i havent drove the car yet. But was wondering if anyone else have done this. (i dont want to bring up 15+ year old threads asking cause they probably wont remember. im sorry but i dont have pictures.