Thread: The fabrication thread.
View Single Post
Old 02-24-2008, 11:19 PM   #330
tknbkthrsdy4anfg
Nissanaholic!
 
tknbkthrsdy4anfg's Avatar
 
Join Date: Nov 2006
Location: Smackramento, CA
Age: 37
Posts: 1,941
Trader Rating: (0)
tknbkthrsdy4anfg is close to perfectiontknbkthrsdy4anfg is close to perfectiontknbkthrsdy4anfg is close to perfectiontknbkthrsdy4anfg is close to perfectiontknbkthrsdy4anfg is close to perfectiontknbkthrsdy4anfg is close to perfectiontknbkthrsdy4anfg is close to perfectiontknbkthrsdy4anfg is close to perfectiontknbkthrsdy4anfg is close to perfectiontknbkthrsdy4anfg is close to perfectiontknbkthrsdy4anfg is close to perfection
Send a message via AIM to tknbkthrsdy4anfg
Quote:
Originally Posted by driftstyre View Post
Started and finished the new oil pan today. The flange is 1/2" T6 that I cut on the bridgeport with the rotary wheel to do the contours. Jesus that was lame. I'm still in the stone ages here. The baffles aren't yet welded in, drain plug as well.
Bill, that looks awesome, what did you do to keep the flange from warping while you welded?
__________________
Quote:
Originally Posted by Brian
well I suppose you can imagine it like a parking space that you think "gosh, I’ll never fit in there" But then you fold in the side view mirrors and what do you know, your in.

$pending dead pre$ident$ J@CK@TT@CK!
tknbkthrsdy4anfg is offline   Reply With Quote