[tb13]

New manifold got bolted up to start the day, kinda hate the heat wrap job, but it'll do. I really need to chill and just run something as is.



I've been trying to find a proper valve cover hardware solution without spending a ton of cash for a while now and think I finally have a winner. Found some Subaru valve cover washer/grommets that fit well and some nice looking stainless nuts, looks great and retains the factory studs.



Remembered my caged shell had some tubes tack welded in the front that would easily transfer over to this car with a bit of work. Still have no idea how to properly weld, but I got them chopped down a bit, plates modified and both roughly in place.