Zilvia.net Forums | Nissan 240SX (Silvia) and Z (Fairlady) Car Forum - View Single Post

NoFlex · 02-02-2018, 11:42 AM

So my Rear upper control arms have play (ISR V1 ARMS S13) in the heim joints/ rod ends. I want to replace just the rod end and not the whole control arm!!

I measured the size of the rod end and it is M14X2.0X45mm

The opening for the rod bore (for the bolt to go through) without the two washer things installed is 17mm.

For some reason all the replacement rod ends I am finding have a 14mm bore?

Has anyone ever replaced these before?

Link of the replacements I found:

http://www.midwestcontrol.com/part.php?id=3002

02-02-2018, 11:42 AM	#1
NoFlex Zilvia Member Join Date: Jan 2015 Location: USA Posts: 236 Trader Rating: (0)	Replacing Heim Joints/Rod Ends RUCA So my Rear upper control arms have play (ISR V1 ARMS S13) in the heim joints/ rod ends. I want to replace just the rod end and not the whole control arm!! I measured the size of the rod end and it is M14X2.0X45mm The opening for the rod bore (for the bolt to go through) without the two washer things installed is 17mm. For some reason all the replacement rod ends I am finding have a 14mm bore? Has anyone ever replaced these before? Link of the replacements I found: http://www.midwestcontrol.com/part.php?id=3002