Thread: How low can you go v. 2.1 - S/Z-chassis only
View Single Post
Old 03-08-2006, 03:57 PM   #105
Slip&Sliden 240
Zilvia Member
 
Slip&Sliden 240's Avatar
 
Join Date: May 2004
Location: Washington
Age: 37
Posts: 237
Trader Rating: (1)
Slip&Sliden 240 is close to perfectionSlip&Sliden 240 is close to perfectionSlip&Sliden 240 is close to perfectionSlip&Sliden 240 is close to perfectionSlip&Sliden 240 is close to perfectionSlip&Sliden 240 is close to perfectionSlip&Sliden 240 is close to perfectionSlip&Sliden 240 is close to perfectionSlip&Sliden 240 is close to perfectionSlip&Sliden 240 is close to perfectionSlip&Sliden 240 is close to perfection
Quote:
Originally Posted by TheTimanator
So is this how everybody gets their KTS's that low? I was under the impression that that wasn't really safe in the rear. I'm happy with my current ride height although it could go lower. But one side of the car is still higher than the other. I think something is bent b/c when I put the coils in both sides were set the same.
Anyway, I'll post some pic as soon as I can get some new ones. My frame rails are 2.5" off the ground
I have 2 collars removed on mine in the front. The rear I have slop but not enough to where it leaves the little guides on the collar.
Slip&Sliden 240 is offline