View Single Post
Old 11-24-2008, 04:37 PM   #3067
bboyoracle
Zilvia FREAK!
 
Join Date: Mar 2003
Location: Silver Spring MD
Age: 40
Posts: 1,215
Trader Rating: (8)
bboyoracle is a splendid one to beholdbboyoracle is a splendid one to beholdbboyoracle is a splendid one to beholdbboyoracle is a splendid one to beholdbboyoracle is a splendid one to beholdbboyoracle is a splendid one to beholdbboyoracle is a splendid one to beholdbboyoracle is a splendid one to beholdbboyoracle is a splendid one to beholdbboyoracle is a splendid one to beholdbboyoracle is a splendid one to behold
Send a message via AIM to bboyoracle
^that car was parted out. I now have the bride seats and coilovers

Pictures:







SPEC SHEET/PARTS LIST
1990 Nissan 240sx
- Seibon Carbon doors
- Seibon Carbon hatch
- Seibon Carbon hood
- Sparco trunk latch
- Nismo exhaust hanger set of 3
- Buddy Club Spec II
- Cusco sway bar Front- Rear
- Cusco strut bar
- Peterson catch can
- Takata Racing harness
- Kics R40 lugnuts
- Nismo Motor and Tranny Mounts
- Extendid studs all around
- Promod Custom 12-point roll cage
- Fuel Safe 15 gallon fuel cell
- Weldon fuel pump 2115
- Weldo fuel pressure regulator
- JDM S13 rear end w/4.10 final drive and custom oversize axles, Kaaz two-way limited slip
- Cannon Engineering custom drive shaft
- New OEM wire harness
- Stack digital dash cluster ST8130
- Kei Office XT coilover kit
- Syline R32 brake upgrade
- Five lug conversion
- Enkie RPF1 17X10 18 offset in rear
- Enkie RPF1 17X9 1/2 28 offset in front
- Bride seats

ENGINE - SR20DET

- HKS Cams stage 3
- HKS Lash killer kit ( solid lifter kit )
- Greddy Valve Springs
- Crower Retainers
- Ferrea Custom Valves
- Greddy Rocker Arm Stoppers
- Toda Adjustable Cam Sprockets
- Cylinder head square ported and polished by Mo Flo
- Apex’I 87mm head gasket
- Greddy 87mm pistons & rings
- Greddy rods & wrist pins
- Golden Eagle sleeves
- New OEM Oil Pump
- New OEM Rear Main Seal
- ARP Main Bolts
- Greddy Head Studs
- Greddy Oil Pan
- OEM Main and Rod Bearings
- ATI crank pully
- Exedy triple plate carbon clutch kit
- B&M short shifter
- Nismo shifter
- Greddy Electronic Boost gauge
- Greddy Electronic oil pressure gauge
- Greedy Electronic EGT gauge
- Greedy Electronic Boost controller
- Greddy Turbo timer
- Greddy Intake Manifold (ported by Mo Flo) w/custom 90mm throttle plate, Q45 throttle body
- Greddy Oil pan
- Custom Full-Race stainless turbo manifold
- Custom Fuel Rail
- Rochester 1600cc Injectors
- SplitFire Coil Pack
- Garrett GT40R dual ball bearing turbocharger
- 44mm Tial Wastegate
- 50mm Tial Blow-Off Valve
- Full-Race Custom 4” stainless down pipe
- Full-Race Custom stainless dump tube
- Full-Race Custom stainless exhaust manifold
- Apex’I GTR Intercooler Core
- Apex’I 3” IN Tanks
- Burns 3" aluminum intercooler U bend piping
- Burns 4" stainless muffler
- Burns 4" stainless piping
- Meziere electric water pump
- Koyo radiator
- Dual FAL fan's
- Blitz upper radiator hose
- Samco lower radiator hose
- AEM 3 1/2 Bar MAP sensor
- AEM EMS engine management
- AEM WEGO wide band a/f sensor w/gauge
bboyoracle is offline   Reply With Quote