brake bleeding
Bench bleed master cylinder with fittings and lines from wrecking yard.Make sure you cut the front and rear lines from donor car ,long enough to curl upwards and into brake fluid reservoir ,so you can see air bubbles escaping as you bench bleed it.There are some cheap plastic kits ,but i prefer this method better.
When bleeding brakes, always begin with the wheel furthest from MC ,On US Cars RR,LR.FR,FL ,Use a see through hose and an empty plastic water bottle . and take your six point closed end ,8 or 10mm wrench put it on bleeder fitting first and take the clear hose and install it on bleeder fitting ,make sure its on tight ,if loose use a zip tie.Bleed calipers and make sure the other end of hose is in the water bottle below fluid level, so you can see all air escape the line.
__________________
|