Quote:
Originally Posted by TheRealSy90
Would it be better to just have Villains make you a new set of stubs that are 10-15mm longer by the axle flange? Then you wouldn't need that spacer at the hub spline.
|
This was essentially why I asked. I'm on the driftworks geomaster rear knuckles and I love the correction on the arms but I'm worried about compatibility issues when running the villains stubs because these knuckles do push the hub out just a bit, like deolio described. I'd like to avoid using the spacers but that may be the way to go unless they'd like to extend the stub a bit, but I'm not sure if that's possible granted they probably have a jig for this - let's see what they say