Quote:
Originally Posted by canadians14sr20det
So I have run the car without exhaust, ensuring nothing is touching in any way. Vibration is still present.
Also the vibration is present with the car in gear and clutch in. The pinion angle was measured and set correctly. Its also not speed sensitive. I'm positive it's not driveshaft related.
There is another thread about this on here where the op mentioned it may be caused by worn input shaft bearings allowing some slop. Thats gonna get replaced when/if I do a mazworx vq->Sr bell housing. Next up is the damper on the side of the tranny and then the ATI super damper. Transmission rebuild and new bellhousing is the last resort.
|
I'm not of any help to your current issue, but when it comes time to buy that adapter shoot me an email and I'll cut you a deal on it!