Quote:
Originally Posted by SilviaSR20DET
In order to get the aem uego to log into nistune you must:
1)set the wideband to the correct look up table in this case "DLPADConverter"
2)under wideband type select aem uego gauge
3)select what com port it is reading from by going through control panel and then system device manager to find out where your usb/adapter is currently connected to.
4)Then you have to install tera term pro (can be dled for free and i believe if you serach under the nistune forums he provided a dl for it) and setup your com port so taht nistune can recognize the AEM.
|
i also have the AEM UEGO, and i'm running a Type 3 nistune board and i'm having a hellova time trying to figure out how to make it work... it's like calling the phone company, and having to go through all that telephony to get to a human being... with no human being at the end....
can i get a full comrehensive How To, with any available downloads, and hardware locations to make this work?
i have one USB port on my laptop, which, will make it hard to data log with the Nistune USB in it... i was trying to find a way to hardwire the AEM direcetly into the ECU/Nistune board, if possible....